TT-2™ Turntable Interconnect with ground wire

• 3 pure copper Kimber VariStrand™ conductors with Teflon® insulation.


• Pure copper, Teflon® insulated Kimber ground wire.


• Kimber's unique woven geometry.


• High-performance Kimber mesh screen.


• Kimber UltraPlate™ phono plugs.

For some time We have offered our Russ Andrews TT-1™ phono to phono interconnect, specifically designed for connecting turntables to phono stages.

Traditionally, detachable tonearm cables were the preserve of higher-end turntables and often had a straight or right-angle 5 pin DIN plug (as offered on Kimber tone arm cables) to connect to the tonearm; the lower-priced and mid-range turntables usually had a captive arm cable.

However, over the past few years, we have seen more and more turntable manufacturers, particularly of affordable and mid-range models, fitting phono sockets to their turntables to allow the use of a higher performance traditional phono to phono interconnect.





Unlike almost all other analogue signal cables in a Hi-Fi system, it’s important that this turntable cable is screened to prevent pick up of hum, particularly if using a moving magnet cartridge. The TT-1™ was a fully screened coaxial design using high purity copper and, since it was launched, we’ve been investigating ways in which we could design a higher performance model to deliver even greater performance.

The answer was to look at the fundamental design of the cable. Whereas TT-1™ is a cost-effective performer based on a coax construction, the new TT-2™ utilises a more traditional braided Kimber design, using three of Kimber's woven, Teflon®-insulated pure copper VariStrand™ conductors per channel, over which is run a high-performance Kimber screen. This is connected in a very specific way to reduce noise pick up and prevent hum while maintaining signal fidelity.







TT-2™ comes with its own grounding wire, of the same quality as the Kimber wire used in the interconnect, for use where your turntable is fitted with a grounding terminal. Most turntables do have one, but not all, so for convenience we include it as a separate item. TT-2™ can be used with all turntables, whether they are fitted with a moving magnet or a moving coil cartridge.

The benefits of using Kimber's woven design are clear – in our listening tests, music flows more ‘freely’, sounding cleaner, clearer, more musical and more relaxing to listen to. Like the TT-1™, we recommend using TT-2™ specifically for the turntable to phono stage connection.


3 pure copper Kimber VariStrand™ conductors

---

Teflon® insulation

---

High performance Kimber mesh screen

---

Pure copper, Teflon® insulated Kimber ground wire fitted with 5mm spades

---

Braided Kimber geometry

---

Kimber UltraPlate™ phono plugs

---

25 year Lifetime Warranty

---

Don't forget! We're so confident in the performance of this product that it is covered by our 60 Day Home Trial with Money Back Guarantee. Buy the product and if you're not completely satisfied, you can return it within 2 months for a refund. For full details click here.

---